PCAN-PCI Express FD Single Channel

Article number:IPEH-004026
Product lifecycle: Active

The plug-in card PCAN-PCI Express FD allows the connection of a PC with PCI Express slots to CAN FD and CAN networks. There is galvanic isolation of up to 500 Volts between the computer and CAN sides. The card is available as a single, dual, or four-channel version.

Product propertys

System Core
port	1 x High-speed CAN channels (ISO 11898-2)
bitrate	CAN bit rates from 25 [kbit/s] up to 1 Mbit/sCAN FD bit rates for the data field (64 bytes max.) from 25 [kbit/s] up to 12 Mbit/ [s]
protocol	CAN 2.0 A/B, CAN FD
isolation	Galvanic isolation on the CAN connection up to 500 [V], separate for each CAN channel
power	5-Volt supply to the CAN connection can be connected through a solder jumper, e.g. for external bus converter
Internal Expansion Bus
type	PCIe
I/O interface
I/O interface	1 x DSUB9CAN bus connection via D-Sub, 9-pin (in accordance with CiA® 303-1)
Environmental
Operating temperature	Extended operating temperature range from -40 to 85 [°C]
Mechanic
mount	PCIe x1PC plug-in card for PCI Express slots

Product Description

The new CAN FD standard (CAN with Flexible Data rate) is primarily characterized by higher bandwidth for data transfer. The maximum of 64 data bytes per CAN FD frame (instead of 8 so far) can be transmitted with bit rates up to 12 Mbit/s. CAN FD is downward-compatible to the CAN 2.0 A/B standard, thus CAN FD nodes can be used in existing CAN networks. However, in this case the CAN FD extensions are not applicable.

The monitor software PCAN-View and the programming interface PCAN-Basic for the development of applications with CAN connection are included in the scope of supply and support the new standard CAN FD.

Back to the Category main page

PCAN-PCI Express FD Single Channel(IPEH-004026)
Illustration may be similar

	call
	+49 (089) 542716-0
	Show shopping cart
	Advice and support with over 30 years of experience